My Account
Sign up, and you can make all message times appear in your timezone.
Sign up
Report problem with this ad
Start a related thread
Start a related poll
Reply via Boardmail
Nov 7, 2024
9:55
:01
pm
drdrcoug
Redshirt Freshman
Correct. Ignites. Full fan comes on. Runs for about 45 minutes or so.
Start a related thread
Start a related poll
Reply via Boardmail
Report problem with this ad
drdrcoug
Bio page
drdrcoug
Joined
Jun 11, 2019
Last login
Nov 7, 2024
Total posts
158 (4 FO)
Report problem with this ad
Messages
Author
Time
Furnace question
drdrcoug
Redshirt Freshman
Nov 7, 9:39pm
RE: Furnace question
StantonMac
Nov 7, 9:41pm
My advice: Leave it flipped on.
Rusty Crab Daddy
Nov 7, 9:41pm
I have a thought but I have to leave the building before I'm locked in.. will check back when I'm home if no one chimes
timpjynx
Nov 7, 9:44pm
So if you flip the switch it runs successfully for a cycle but then fails after
tkh9
Nov 7, 9:45pm
Ya, I'm not sure hence my post. Sounds like he turns it on and it works.
Rusty Crab Daddy
Nov 7, 9:46pm
I thought your advice was solid.
tkh9
Nov 7, 9:48pm
Correct. Ignites. Full fan comes on. Runs for about 45 minutes or so.
drdrcoug
Nov 7, 9:55pm
RE: Furnace question
yovocoug
Nov 7, 9:47pm
Does your furnace have an impeller motor?
AggieWeekendCougar
Nov 7, 9:47pm
Maybe? It looks like there is a smaller motor that runs for a while before the main one kicks on.
drdrcoug
Nov 7, 9:59pm
Even when not starting properly, does that one kick on?
AggieWeekendCougar
Nov 7, 10:00pm
Yes. That one runs for 30 seconds or so every few minutes.
drdrcoug
Nov 7, 10:02pm
After it has been running for a minute or two, can you see or hear an ignition
AggieWeekendCougar
Nov 7, 10:05pm
Check your air filter. Make sure it’s clean.
Blue Print
Nov 7, 9:47pm
How long does it run after you get it to turn on? There is a small metal rod cal
BYUBuckeyeGoCougs
Nov 7, 9:48pm
I cleaned mine once every few weeks for years.
Crazy Joe Davola
Nov 7, 9:51pm
this is where I was going.. cleaned mine with sandpaper for a season or three before finally replacing it.
timpjynx
Nov 7, 10:45pm
My guess: one of your kids climbed into the attic where your HVAC is and flipped that switch thinking it was the light
SaturdaySpecialDay
Nov 7, 9:48pm
I think that the switch is there to make it easier to work on the unit without
Cheap Seats
Nov 7, 9:49pm
My whole house is full of “interesting electrical choices”
drdrcoug
Nov 7, 9:57pm
We have a switch by our furnace for this reason only, 1986 build Utah rambler
tyler durden
Nov 7, 10:58pm
Try cleaning the flame sensor, YouTube will show you how.
Provolone
Nov 7, 9:50pm
There should be a blinking LED on the control panel
dug
Nov 7, 11:03pm
Report problem with this ad
Posting on CougarBoard
In order to post, you will need to either
sign up
or
log in
.
Report problem with this ad
