My Account
Sign up, and you'll be able to vote in polls.
Sign up
Report problem with this ad
Start a related thread
Start a related poll
Reply via Boardmail
Nov 7, 2024
9:50
:36
pm
Provolone
Walk-on
Try cleaning the flame sensor, YouTube will show you how.
Start a related thread
Start a related poll
Reply via Boardmail
Report problem with this ad
Provolone
Bio page
Provolone
Joined
Dec 18, 2022
Last login
Nov 7, 2024
Total posts
1 (0 FO)
Report problem with this ad
Messages
Author
Time
Furnace question
drdrcoug
Redshirt Freshman
9:39pm
RE: Furnace question
StantonMac
9:41pm
My advice: Leave it flipped on.
Rusty Crab Daddy
9:41pm
I have a thought but I have to leave the building before I'm locked in.. will check back when I'm home if no one chimes
timpjynx
9:44pm
So if you flip the switch it runs successfully for a cycle but then fails after
tkh9
9:45pm
Ya, I'm not sure hence my post. Sounds like he turns it on and it works.
Rusty Crab Daddy
9:46pm
I thought your advice was solid.
tkh9
9:48pm
Correct. Ignites. Full fan comes on. Runs for about 45 minutes or so.
drdrcoug
9:55pm
RE: Furnace question
yovocoug
9:47pm
Does your furnace have an impeller motor?
AggieWeekendCougar
9:47pm
Maybe? It looks like there is a smaller motor that runs for a while before the main one kicks on.
drdrcoug
9:59pm
Even when not starting properly, does that one kick on?
AggieWeekendCougar
10:00pm
Yes. That one runs for 30 seconds or so every few minutes.
drdrcoug
10:02pm
After it has been running for a minute or two, can you see or hear an ignition
AggieWeekendCougar
10:05pm
Check your air filter. Make sure it’s clean.
Blue Print
9:47pm
How long does it run after you get it to turn on? There is a small metal rod cal
BYUBuckeyeGoCougs
9:48pm
I cleaned mine once every few weeks for years.
Crazy Joe Davola
9:51pm
this is where I was going.. cleaned mine with sandpaper for a season or three before finally replacing it.
timpjynx
10:45pm
My guess: one of your kids climbed into the attic where your HVAC is and flipped that switch thinking it was the light
SaturdaySpecialDay
9:48pm
I think that the switch is there to make it easier to work on the unit without
Cheap Seats
9:49pm
My whole house is full of “interesting electrical choices”
drdrcoug
9:57pm
We have a switch by our furnace for this reason only, 1986 build Utah rambler
tyler durden
10:58pm
Try cleaning the flame sensor, YouTube will show you how.
Provolone
9:50pm
There should be a blinking LED on the control panel
dug
11:03pm
Report problem with this ad
Posting on CougarBoard
In order to post, you will need to either
sign up
or
log in
.
Report problem with this ad
